Metal Fabrications

100:100 2 Pack Epoxy Finish

£52.50 / 5 Litre pack

Please select a colour or specify your own

At a glance

  • Use as a full system with 100:006
  • Hard wearing abrasion resistant finish
  • Excellent chemical resistance
  • Conventional spray or brush / roller

Intended Uses

A high performance Epoxy Coating with excellent resistance to most chemicals including battery acid, alkalis, grease, oil, etc.

Details

Colour

Available in a wide range of colours including BS and RAL. Custom colours are also available, subject to commercial considerations.

Gloss Level

Gloss

Volume Solids

Around 45% – 50% dependent on colour

Recommended Film thickness

Typical wet film thickness when applied is 100 microns (50 microns dft).

Theoretical Coverage

Approx 10 square metres per litre at 50 microns dft. NB. The practical coverage rate depends on many factors and will be less than the theoretical figure.

Method of Application

Apply by conventional spray to suitably prepared substrates. Not suitable for airless or air-assisted airless spray.

NB. Not recommended for hot spray or electrostatic application.

Drying Time

Touch Dry ……. 2 – 6 hours.
Handle Dry ….. Overnight.
Full Cure ……… 7 – 10 days dependant on temperature

(Drying times are quoted at 20°C and will vary with actual conditions such as: film thickness, air movement, temperature and humidity.)

NB. The drying time depends on the ambient temperature, air movement, and relative humidity and will be dramatically retarded where an excessive amount of paint has been applied. In extreme cases coating failure may occur when applied when adverse conditions such as in low temperatures and high humidity prevail during application or the drying process.

Core colours for this product
Review all colours
Still not found your colour?

If you can't find the exact colour you're looking for then type your specific colour reference here.


Base and Hardener