600:503 ST1Ktop
£60.10 / 5 Litres
At a glance
- Waterborne coating with proven adhesion to a wide range of substrates
- Non-toxic environmentally friendly coating
- Fast drying
- Excellent coverage
Intended Uses
ST1Ktop is a high quality waterbased sheen finish that has shown proven adhesion to a wide variety of difficult to paint substrates, making it ideally suited to the modular building and container industries. These will include carbon steel, galvanised steel (new and weathered), aluminium (including untreated), plastisol sheeting, pre-painted surfaces, glass, ceramic tiles, wood, GRP and certain rigid plastics.
It is a non-toxic, lead free environmentally friendly waterborne coating that contains no ingredients that are classified as being hazardous to the environment.
Details
Colour
Available in a wide range of lead-free colours including BS and RAL. Custom colours are also available, subject to commercial considerations.
Please note we cannot manufacture metallic or zinc rich colours in waterbased products.
Gloss Level
Sheen
Volume Solids
Around 42% dependent on colour
Recommended Film thickness
Typical wet film thickness when applied as a finish is 83 microns (35 microns dft).
Theoretical Coverage
Approx 12 square metres per litre at 35 microns dft. NB. The practical coverage rate depends on many factors and will be less than the theoretical figure.
Method of Application
Can be applied by a variety of application methods including airless spray or air assisted airless spray (13-15 thou tip).
NB. Not recommended for hot spray or electrostatic application.
Drying Time
Touch Dry .…. 15-30 minutes.
Handle Dry ….. 30 minutes.
Full Cure …. 7 days
(Drying times are quoted at 20°C and will vary with actual conditions such as: film thickness, air movement, temperature and humidity.)
NB. The drying time depends on the ambient temperature, air movement, and relative humidity and will be dramatically retarded where an excessive amount of paint has been applied. In extreme cases coating failure may occur when applied when adverse conditions such as in low temperatures and high humidity prevail during application or the drying process.
If you can't find the exact colour you're looking for then type your specific colour reference here.
