101:100 2 Pack Epoxy Floorpaint
£70.10 / 5 Litre pack
At a glance
- Hard wearing abrasion resistant floor paint
- Excellent chemical resistance
- Conventional spray or brush / roller
- Suitable for medium to heavy traffic
Intended Uses
A high performance Epoxy Floor Coating with excellent resistance to most chemicals including battery acid, alkalis, grease, oil, etc. Suitable for medium to heavy traffic.
Details
Colour
Available in a wide range of colours including BS and RAL. Custom colours are also available, subject to commercial considerations.
Gloss Level
Gloss
Volume Solids
Around 45% – 50% dependent on colour
Recommended Film thickness
Typical wet film thickness when applied is 100 microns (50 microns dft).
Theoretical Coverage
Approx 10 square metres per litre at 50 microns dft. NB. The practical coverage rate depends on many factors and will be less than the theoretical figure.
Method of Application
Apply by brush or roller to suitably prepared substrates. Not suitable for airless or air-assisted airless spray.
NB. Not recommended for hot spray or electrostatic application.
Drying Time
Touch Dry ……. 2 – 6 hours.
Handle Dry ….. Overnight.
Full Cure ……… 7 – 10 days dependant on temperature
(Drying times are quoted at 20°C and will vary with actual conditions such as: film thickness, air movement, temperature and humidity.)
NB. The drying time depends on the ambient temperature, air movement, and relative humidity and will be dramatically retarded where an excessive amount of paint has been applied. In extreme cases coating failure may occur when applied when adverse conditions such as in low temperatures and high humidity prevail during application or the drying process.
If you can't find the exact colour you're looking for then type your specific colour reference here.
